"The 16in. ZX Series large spindle bore lathe is designed exclusively by with a 3 1/8in. bore spindle supported by two tapered and one ball bearing. Chrome molybdenum headstock gears are hardened, ground and shaved. Universal gearbox allows inch, metric, diametric and module pitch threads, no change gears required. Carriage features one-shot lubrication and Turcite B on bed sliding surfaces. Thread Cutting in. 1 5/8-72, Thread Cutting mm 05-20, Volts 230/460 pre-wired 230, Speed RPM 25-1,800, Spindle Speeds qty. 12, Width Between Centers in. 40, Carriage Travel in. 35, Dimensions L x W x H in. 98 x 40 x 48, HP 7.5, Stand Included Yes. T-slotted compound slide featuring a four-way tool post One-piece cast iron base absorbs vibration allowing heavier cuts High-quality ANSI Class 50 wear-resistant cast iron bed ways are hardened and ground Removable gap allows up to 25 7/8in. diameter work Five-position automatic carriage stop increases productivity Attractive chrome control levers, dials and knobs Tolerance test certificate included 10in. 3-jaw scroll chuck with top reversing jaws 12in. 4-jaw independent chuck 12in. face plate Four-way tool post Follow rest Large-capacity steady rest Fully integrated coolant system Full-length splash guard and coolant return Large, easy-to-use foot brake Articulating halogen work lamp Centrally located controls with jog button Threading dial Mounting pads and levelers Spindle sleeve MT-7 to MT-5 Dead center"