Northern Tool Ratings and Reviews
Shop Now At Northern Tool

Customer Reviews for "Honda 688cc GX Series V-Twin OHV Engine with Electric Start - 688cc, 1 1/8in. x 2 29/32in. Shaft, Model# GX690RHTDW"

"Honda 688cc GX Series V-Twin OHV Engine with Electric Start - 688cc, 1 1/8in. x 2 29/32in. Shaft, Model# GX690RHTDW"

Item# 13597
"The Honda 688cc GX Series V-Twin Engine is designed to offer higher horsepower, improved adaptability, quiet operation and greater fuel economy. Meets EPA and CARB emission levels standards. This engine is ideal for construction/industrial equipment, pressure washers, commercial lawn and garden equipment, tillers/cultivators, generators, ag equipment, small vehicles, water pumps and forestry equipment. The image shown is not reflective of the actual item shipped. There is no control panel as shown in the image. Fuel Pump Boost type, Flywheel Brake No, Ignition System Electrical, digital CDI w/variable ignition timing, Charging System Amps 20, Carburetor Horizontal, two-barrel butterfly valve, internal vent, Max. RPM 3,600, Governor System Mechanical, Application Pressure washer, lawn/garden equipment, generator, small vehicle, water pump, Crankshaft T type, Choke Control Remote, Oil Capacity qt. 2.1, Cooling System Air cooled, Shaft Diameter in. 1 1/8, Lubrication System Forced lubrication, Engine Type GX series OHV V-Twin, Muffler Included No, Throttle Control Remote, Shaft Keyway in. 1/4 key size 6.3mm x 70mm, Air Cleaner Type Dual element, Bearing Type Ball bearing, Fuel Tank No, Mounting Base L x W in. 7 11/16 x 3 25/64 to 4 21/32, Fuel Type Gas, Cylinder Bore Integrated, Compression Ratio 9.31, Rated Power HP 22.2 @ 3,600 RPM, Fuel Filter Fuel strainer, PTO Height in. 5 1/4, Shaft Rotation From PTO Shaft Side Counterclockwise, Low Oil Shutdown No, Cylinders qty. 2, Shaft End Tapped Diameter in./Threads per inch 7/16-20, UNF2B, Dimensions L x W x H in. 15 9/10 x 16 1/10 x 17 1/5, Torque ft./lbs. 35.6 @ 2,500 RPM, Low Oil Alert No, Bolt Circle in. 5, 6 1/2, 7 3/4, Engine Displacement cc 688, Start Type Electric, EPA/CARB Approval California Air Resource Board Yes, Shaft Output Horizontal, Shaft Length in. 2 29/32, Auto Compression Release Yes, Bore x Stroke in. 78 x 72. No control box Fuel tank and muffler not included 50-state compliant engine"
Average Customer Rating:
5 out of 5
5
 out of 
5
(3 Reviews) 3
Open Ratings Snapshot
Rating Summary (3 reviews)
5 stars
3
4 stars
0
3 stars
0
2 stars
0
1 star
0
3 of 3(100%)would recommend this product to a friend.
Customer Questions & Answers:
1 Question | 1 Answer
Customer Reviews for "Honda 688cc GX Series V-Twin OHV Engine with Electric Start - 688cc, 1 1/8in. x 2 29/32in. Shaft, Model# GX690RHTDW"
Review 1 for "Honda 688cc GX Series V-Twin OHV Engine with Electric Start - 688cc, 1 1/8in. x 2 29/32in. Shaft, Model# GX690RHTDW"
Overall Rating:
5 / 5
5 / 5

A real time saver

,
February 12, 2014
By Cameron808
from Florida
" I installed this on my go-cart to replace the 5hp Brigs that was worn out. I cranked it up and it immediately transported me to the moon. I will try again later with a lower octane fuel and see if it will slow down a little. "
Describe Yourself: Professional
+5points
5out of 5found this review helpful.
Thank you! You have successfully submitted a comment for this review.
Review 2 for "Honda 688cc GX Series V-Twin OHV Engine with Electric Start - 688cc, 1 1/8in. x 2 29/32in. Shaft, Model# GX690RHTDW"
Overall Rating:
5 / 5
5 / 5

Honda 690cc Engine

,
May 8, 2012
By Metricmechanic
from Casper,Wy
" I used this engine to replace a worn out unit on a powerwasher. I was able to increase the output pressure on the washer by 400 psi. This engine starts easier and is more economical to run than the old unit. A REAL POWERHOUSE! "
Describe Yourself: Professional
+4points
8out of 12found this review helpful.
Thank you! You have successfully submitted a comment for this review.
Review 3 for "Honda 688cc GX Series V-Twin OHV Engine with Electric Start - 688cc, 1 1/8in. x 2 29/32in. Shaft, Model# GX690RHTDW"
Overall Rating:
5 / 5
5 / 5

Repowered Garden Tractor

,
August 1, 2011
By DougTucker
from Crystal Lake, IL
Reviewer Images
(click to see full-size image)
User submitted photo
User submitted photo
" I installed the Honda GX690 on my 1973 garden tractor as a replacement for the original 16HP engine. The engine runs smoothly and is a good upgrade that will most likely outlast me. "
Describe Yourself: Home Handyman
+13points
15out of 17found this review helpful.
Thank you! You have successfully submitted a comment for this review.