Northern Tool Ratings and Reviews
Reviews Home > Hand Tools Reviews > Tap + Die Sets Reviews

Tap + Die Sets Reviews

Overall Rating:5 out of 5 stars.
"I looked at many different tap & die sets. This set has the best ratching die starter that i have never seen before great great great! The hole set cuts so good and easy. the best set I ever used."... (read full reviews)
Overall Rating:5 out of 5 stars.
"I like this kit very much. I really like the ratching handle."... (read full reviews)
Overall Rating:5 out of 5 stars.
"This pipe tap set saved me from buying another stock water tank. I was able to clean the threads of a 1-1/4 pipe on the water inlet for a new fitting. Just wish Klutch offered a larger male pipe tap"... (read full reviews)
Overall Rating:5 out of 5 stars.
"This tool is the one of the best tools ever invented. This is the ultimate tap handle and its working exelent in close and tight places. highly recomended."... (read full reviews)
Overall Rating:4.8 out of 5 stars.
"Excellant tool for the money. Would recommend it for any shop needing a multiplier."... (read full reviews)
Overall Rating:4 out of 5 stars.
"Sturdy and precision cutting. Portable case management is a plus"... (read full reviews)
Overall Rating:3.5 out of 5 stars.
"i use them every day, the set has everything i need to fix any bolts i have problems with"... (read full reviews)
Overall Rating:3.2 out of 5 stars.
"I have not used this product yet. It looks like a good set to some other sets I have seen or used."... (read full reviews)
Overall Rating:3 out of 5 stars.
"To make a good pipe thread you need a pipe tap reamer to go with the pipe tap and a good threading oil."... (read full reviews)
Overall Rating:2.3 out of 5 stars.
"This tool worked marginally through about 6 joints of 1 1/4 but the ratcheted cracked and then the 3/4 die feel apart. Knowing that it was a cheep tool i.e. inexpensive, I used it with care but it"... (read full reviews)
Overall Rating:1 out of 5 stars.
"Went to use the 1/4" tap - could not tighten very securely into tap handle. Went to tap a hold through 3/16" plate steel, and the tap cutting edges just rounded over. Save your money and buy a"... (read full reviews)