"I purchased two of these switches and mounted them in the dash on my minni dozer to operate the front actuator for my dozer blade and one to operate the actuator for the rear hitch assembly to raise"... (read full reviews)
"I purchased two of these actuators to put on a minni dozer I built in kit form from the Struck Corporation and installed one on the front to raise and lower the dozer blade. I put the other one on the"... (read full reviews)
"excellent workmanship,looks like it is made in usa. using actuator for raising and lowering deflector on a 60"snow blower 3 point hitch mounted. easily changes deflection while blowing snow."... (read full reviews)
"I used this actuator as an easy remedy to raise and lower a pull behind tiller I use with my garden tractor. It saves having to deal with hydraulic modifications and much cheaper."... (read full reviews)
"I bought this relay to control a ball-screw linear actuator (Northern Tools Item# 27322). This relay provides dynamic braking for the actuator connected to it and works amazingly well to stop unwanted"... (read full reviews)
"I bought this actuator to give my ATV plow four way capacity without getting off the machine. After some simple modifications to the plow itself the actuator was installed and has worked flawlessly."... (read full reviews)
"I didn't get a chance to mount it yet. Should work good. I bought it to put down pressure on my ATV scoop bucket attachment. I also will hook it up to my ATV dump trailer. When it is full of gravel I"... (read full reviews)
"Put this on a green machine after the dealer quoted $900 to replace OEM unit. I had to slightly trim the ears on the machine, but otherwise a perfect fit. Good quality product will recommend to all!"... (read full reviews)
"These aluminum brackets are well made, however the claim of a 1/4" pin is not exactly accurate. The actual pin is a surprisingly thin hex head threaded bolt with a rolled steel SLEEVE over it to take"... (read full reviews)
"Questions were answered via e-mail to Northern Tool.
I use only channels 1 & 2 to extend & retract actuator.
Supplied wire harnesses ( 1 harness for channels 1 & 2 -internal relays and 2nd harness for"... (read full reviews)
"Great easy to use controller (idiot proof) but needs a longer wiring harness between the controller and actuator, like 15 to 20ft had to make my own extension harness, but worked great for a remote"... (read full reviews)