"I have one of these motors for 10 years and NOT had any problems. And will order another one soon for another compressor I'm putting together."... (read full reviews)
"Replaced my 5 HP air compressor motor with this. Simple change out. (about 15 minutes) Came packaged very well and on time. This motor looks to be using about 2 amps less than my old motor. Great!"... (read full reviews)
"I use this motor on a large rock saw. It has done a fantastic job. No overheating, I can turn the saw off in the middle of a cut and it will start right back up, no problem. Highly recommend this"... (read full reviews)
"there i was with a table saw with a one quarter hp motor. coudnt cut a 1 by 4 without stalling the blade. so i checked out northern tool and found this motor by leeson. 1 and 1 half hp of muscle."... (read full reviews)
"This motor ran the go cart exactly as planned with no problems. To put things in perspective: the cart itself weighs @ 200 lbs besides the driver. So a good sturdy motor was needed and this filled the"... (read full reviews)
"It was easy to set up and start working. I love this motor. There was a lightning storm and it burned up another brand motor. With this one, I just hit the reset button and it started right up. I run"... (read full reviews)
"The LESSON electric motor I bought worked out just right for running a Lathe I have in my shop. This motor runs quite, has power, and mounts very easy. I would buy a LESSON motor again.
Jerry"... (read full reviews)
"I selected the Leeson Woodworking electric motor to replace my existing "replacement" motor in my table saw. The original replacement had been provided by the manufacturer of the saw and it never"... (read full reviews)
"This motor was purchased to drive a home made air compressor rated for 5HP. I considered purchasing the smaller 5HP motor (Model# 116511) but elected to go with this model (Model# 102892). I am here"... (read full reviews)
"My goal for this motor is to drive a custom 2x72 belt grinder and will also power various buffing wheels that mount to the same chassis. I have yet to finish the actual grinder but have completed the"... (read full reviews)
"Easy to install - the holes lined up well. Works great! No complaints. We use it for an exhaust fan in our barn. I highly recommend it."... (read full reviews)
"Wasn't quite sure how well the motor would perform in the type of application I had in mind for it, but it worked as if it was made for it! Definitely worth the money, has plenty of torque and overall"... (read full reviews)
"Bought this motor to use as a fan motor inside Poultry houses. Since it was labeled "Heavy Duty" and "Agricultural" use I thought I would give it a try even though the cost exceeded what I would"... (read full reviews)
"make sure you fully understand motor specs the picture of this motor is not the one you will receive base is vertical mount not horz as shown"... (read full reviews)
"Purchased this motor as a replacement for a Dayton motor in a light duty winch application. The motor worked great for 3 months and then developed an intermittent ground fault. It then froze up"... (read full reviews)